Need Front or Rear Remote circuits for a Grapple Bucket, Log Splitter, or TOP-N-Tilt system? We can work with your existing tractor hydraulic circuit to determine the most economical and efficient way to get the hydraulic flow where you need it. We start with a system schematic, and determine the best way to add the hydraulic circuits needed for you specific application.

Pictured is a 3-stack 4-way Spool Valve for Rear and Mid Remote Hydraulic Plugs. The hydraulic flow for the remote circuits is taken from a Power Beyond Circuit from the Loader control valve.

This manual angle and offset rear grader blade required the operator to leave the tractor seat to adjust the blade angle and offset.

With the addition of Rear Remote Circuits, and Hydraulic Cylinders on the swing and offset truniuns, the operator can now control offset, angle, and moldboard tip without leaving the seat.

CK20 Step - $75.00

Logging Tongs - $45.99

      Rigging Blocks

4" 1000 Lb Cap. - $75.00

5" 1200 Lb Cap. - $83.00

4" Snatch Block - $26.95

4" Alum. Snatch Block

            $25.95

Shackles - From $5.75