Michigan Iron & Equipment: Kioti Dealer

DOUBLE SELECTOR VALVES - MANUAL AND ELECTRIC

ELECTRIC DOUBLE SELECTOR VALVES

With the addition of Electric Selector Valves, additional circuits can be added to your existing system without the need for added spool valves. One 2-spool Joystick Valve can be used to control a Front Loader and additional Mid or Rear Circuits with a selector switch near the operators seat.

Picture 1 (Top Picture to Right): Double Electric Selector Valves Mounted on a KIOTI DK45SC. Front Four Plugs Control the Front End Loader, while Rear Four Plugs are Mounted on Rear of Tractor for Running Double Acting Cylinders.

Picture 2 (Avove and Left): Double Electric Selector Valves on Kubota B2910. Valves are Located under Black Cover in Front of Loader Joystick. Again, Front Four Plugs Run the Front End Loader while Rear Four Plugs are Available to Run 2 Double Acting Cylinders.

Picture 3 (Above and Right): Four Rear Plugs Mounted between Rear Axle Housing and Rear Tire on a Kubota B2910.

MANUAL DOUBLE SELECTOR VALVES

Manual Double Selector Valves Work the Same Way as Electric Selector Valves, only Flow is Diverted by a Handle instead of an Electric Solenoid. These Valves are Typically Much Less than an Electric Selector Valve while Still Having all the Functionality.

Pictured Above: Manual Selector Setup on a KIOTI CK35. This Selector Valve allows an Auxilary Valve to Control A Set of Hydraulic Plugs Mounted on the Front of the Front End Loader and a set of Plugs on the Rear End of the Tractor Depending on the Position of the Selector Lever.